Windows 11 Readiness

Key Features

1. It performs the following Windows 11 Hardware requirements checks:
   • RAM 4 gigabytes (GB) or greater
   • Processor (1 gigahertz (GHz) or faster with two or more cores on a compatible 64-bit processor)
   • Device Storage (64 GB or greater available storage)
   • TPM version 2.0
   • Battery Health (Applicable only to laptops)
   • System firmware: UEFI, Secure Boot capable. (Applicable for Physical and virtual machine)
   • Graphics card: Compatible with DirectX 12 or later, with a WDDM 2.0 driver.
2. It performs the following Windows 11 Operating system requirements checks:
   • Windows 10 version 2004 or later
3. It performs the following Windows 11 virtual machine requirements checks:
   • Hyper-V Generation: 2
   • Storage: 64 GB or greater
   • Azure: Trusted launch with vTPM enabled
   • Hyper-V: Secure boot and TPM enabled
   • General settings: Secure boot capable, virtual TPM enabled
   • Memory: 4 GB or greater
   • Processor: Two or more virtual processors
4. Windows 11 readiness compliance using 1E Endpoint Automation

Setup:

• This Product Pack contains both Rules and instructions.
• Upload this Product pack with the help of Tachyon Product Pack Deployment Tool.
• A Guaranteed State Policy named Windows 11 Readiness will be created.
• Guaranteed State Rule Windows 11 Readiness will be created in this policy.
• An Instruction Set named Windows 11 Migration containing all the instructions will be created.

Usage:

1. Review the rule Windows 11 Readiness.
2. The precondition ensures that the check runs on Windows devices if the operating system is not windows 11:
3. Adjust the trigger IntervalHours to meet your requirement:                                     
4. The check if the Windows 11 requirements are met or not will decide if the device is compliant or not:
5. Enable this rule and assign the Windows 11 Readiness Policy to a management group.
6. Deploy the Windows 11 Readiness Policy.
7. Within a period of a day or more you would start seeing the compliance reports on Windows 11 Readiness.
8. You can also manually run the instruction from Explorer to perform various actions or questions related to Windows 11 Readiness.
9. Go to Explorer and run the Windows 11 readiness instruction:                                                                                   
10. You can view the status of the Instruction in 1E Endpoint Troubleshooting immediately after clicking Ask this question. Results will be displayed after instruction is executed on the target devices:
11. This will provide a detailed report of the checks performed on each device. Few columns may show Not Applicable due to requirements being different for physical and virtual machines
12. Chart will provide a bar chart view which is generated from aggregate table data and their count: